The structural analysis software RFEM 6 is the basis of a modular software system. The main program RFEM 6 is used to define structures, materials, and loads of planar and spatial structural systems consisting of plates, walls, shells, and members. The program also allows you to create combined structures as well as to model solid and contact elements.
RSTAB 9 is a powerful analysis and design software for 3D beam, frame, or truss structure calculations, reflecting the current state of the art and helping structural engineers meet requirements in modern civil engineering.
Do you often spend too long calculating cross-sections? Dlubal Software and the RSECTION stand-alone program facilitate your work by determining section properties of various cross-sections and performing a subsequent stress analysis.
Do you always know where the wind is blowing from? From the direction of innovation, of course! With RWIND 2, you have a program at your side that uses a digital wind tunnel for the numerical simulation of wind flows. The program simulates these flows around any building geometry and determines the wind loads on the surfaces.
Are you looking for an overview of snow load zones, wind zones, and seismic zones? Then you are in the right place. Use the Geo-Zone Tool to determine quickly and efficiently snow loads, wind speeds, and seismic data according to ASCE 7‑16 and other international standards.
Would you like to try out the capabilities of the Dlubal Software programs? You have the opportunity to do so! The free 90-day full version allows you to thoroughly test all our programs.
Please check whether you have started the licensed main program RFEM 5 / RSTAB 8 or opened the "viewer" by mistake. This viewer is only used to view files. It is license-free.
If you want to create files, you have to run the licensed main program. If the link does not exist anymore, you can copy the link to the viewer and then remove the "/viewer" addition in the properties.
After installing RFEM 5 or RSTAB 8, you will find three program links of each program family on the desktop. These are the links to the 3D program version, the 2D program version, and a license-free Viewer version.
You have purchased the 3D version of RFEM 5. The 2D version is not a part of your license, so you will receive a corresponding error message when starting this version. Therefore, please start the 3D program link of RFEM. In the 3D version of RFEM 5 (or RSTAB 8), you can also generate 1D/2D structures.